AAP Elite S series Manuel d'utilisateur télécharger pdf (Page 22)

USER FUNCTIONS

STARTING WALKTEST MODE

While in CLIENT mode a User with the proper authority can start walk-test

mode. This special mode latches the alarm signals from detectors at the

keypad initiating the test so that one person can trigger every detector

connected to the alarm then return to the keypad to verify operation. On

terminating Walk-test mode the test results are put into the memory buffer

so they can be viewed at a later time.

To start Walk-test mode while in CLIENT mode press;

The keypad buzzer will beep at 1 second intervals

Next trigger every detector connected to the panel then return to the key-

pad and all of the zones that were triggered will be displayed at the key-

pad.

To terminate Walk-test mode press;

<ENTER>

The keypad will stop beeping and automatically exit CLIENT mode.

ANSWER AN IN-COMING CALL

From time to time your installer may need to access the alarm from a re-

mote PC to make changes to your programming and for security reasons

they may have configured the alarm so that an authorised person on-site

is required to make the alarm system answer the in-coming call. This func-

tion is available in Idle Mode (the panel is not armed or in program mode).

To answer an In-coming Call press;

(You must hold the “control” button down and press “9” within 2 seconds)

Provided the line connected to the alarm was ringing at the time the panel

will now answer the call and allow a remote PC connection.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Pas de commentaire

AAP Elite S series Manuel d'utilisateur Page 22